UP! mini G-Code transcoder part2

Today I made the first test prints.

20mm calibration cube, sliced with Simplify 3D: 0.2 layer height, no infill, 2 perimeter, raft

The 1st print (left) had a much to big extrusion multiplier, which I changed for 2nd print (middle) to a much too small value.  The 3rd print (right) almost had a good value for extrusion (a bit underfeed but it’s usable for calibration)

The video below shows the printer in action. You may notice the much much faster travel speed 🙂

BTW: Support / raft separation was as easy as with UP standard software.